Vicor PI33XX-2X I2C Digital Interface Guide Manuel d'utilisateur télécharger pdf (Page 17)

vicorpower.com Rev 1.0 Cool-Power

800 735.6200 11/2012 Page 17 of 22

PI33XX-2X I

C Digital Interface Guide

Configuration Example - Sync Delay

Type “0001” into the SYNC dialog box. Left click on the “BURN” button.

Figure 20 - SYNC “0001” Burn Phase 1 While Unit Enabled or Disabled

The first four writes and reads ensure that the three User registers are cleared. Then the test mode register is

selected at address 18h and the test mode 05h is entered. Next, the user is prompted to disable the unit using the

enable pin. The target can be enabled or disabled prior to being prompted to disable. See Figures 20 and 21.

Figure 21

When the user disables the target, another prompt will provide notification to enable the target again as shown in

Figure 22. When the unit is enabled, the output voltage will remain low as if the PI33XX-2X was still disabled. This

is normal. The Picor Buck GUI will next write “01h” into the SYN[3:0] register.

Figure 22 - SYNC “0001” Burn Phase 2 Unit Must be Enabled

The next step prompts the user to disable the target again. After clicking “OK”, Picor Buck GUI will reset from test

mode 5 and then clear the other user registers as shown in Figure 23. Picor Buck GUI will display a dialog box to

inform the user of the successful burn completion. When the user enables the PI33XX-2X, it should power up

normally and the burned in changes shall take effect.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22

Pas de commentaire

Vicor PI33XX-2X I2C Digital Interface Guide Manuel d'utilisateur Page 17